WeldPilot
Vulcan OmniPro 220 · multimodal support
Manual-grounded
Ask about duty cycle, polarity, troubleshooting, or setup. Use the chips below, or enable
Hands-free
and say
Hey Pilot
to wake the assistant. After each answer it goes back to standby until you say
Hey Pilot
again.
MIG 200A on 240V duty cycle
Show flux-core polarity
Why is my weld porous?
Help me choose a process
Set up wire feed
Show front panel controls
What polarity for TIG? Where does ground clamp go?
Wire feed motor runs but wire does not feed
Artifacts (mobile)
No artifact yet.